Documents › 596213e3791affc7c1754ebf05461182e25d85b7:837-844

642 - BR06_POST2306324_Walden_Luke_Attachment_C_ATF_Bulletin2.pdf

POST board policyreference 2025-11-06 8 pages (file pages 837–844) original file
About this document
Layer
packet: an item in a POST meeting packet
Type as titled
case_attachment (kind from title)
File
596213e3791affc7c1754ebf05461182e25d85b7 application/pdf
Cases
POST 2306324 · Luke Baxter Walden (packet item)

About: Luke Baxter Walden (case)

Page 7 · file page 843 larger image
Image of page 7; its text is alongside
Text: OCR figure: some text describes an image

ATF Firearms & Ammunition Technology Division Bulletin 17-02

Identification (cont.):

Figure: the OCR model's description, not text on the pageA photograph showing a long, cylindrical firearm silencer at the top, and a row of various end-caps and freeze plugs below it, some of which have small holes in the center.

Firearm Silencer

Figure: the OCR model's description, not text on the pageTwo close-up photographs of end-caps. The left one is a polished metal end-cap with a red circle highlighting a central hole. The right one is a duller, possibly oxidized metal end-cap with a red circle highlighting a small hole. A red label 'Indexing holes' with a line points to the hole in the right image.

End-cap

Modified freeze plug

In conclusion, for a device to be considered a “solvent trap” and not a firearm silencer, it must be designed and actually function in such a way to trap and hold cleaning fluids without holes, index markings or other design features that demonstrate it is actually intended to be used for silencing the report of a firearm. Such an item is considered a solvent trap because the statutory definition of silencer does not include otherwise unregulated items simply because they have the capability, or may be adapted, to be used as silencers. Instead, the statute speaks of a device “for” silencing or muffling. Therefore, mere possession of a “solvent trap” or components which could be used in the assembly of a firearm silencer does not necessarily constitute possession of a firearm silencer. Intent must be demonstrated or communicated. For example, indexing holes as shown above demonstrate such intent because these serve no benefit in collecting solvent or debris, but demonstrate the location of holes if these parts are to be used in a silencer.

2G

Figure: the OCR model's description, not text on the pageThe official seal of the ATF Firearms & Ammunition Technology Division, featuring a shield with a gun, a rifle, and a target, surrounded by the words 'FIREARMS & AMMUNITION TECHNOLOGY DIVISION' and 'DEPARTMENT OF JUSTICE'.

ATF Firearms & Ammunition Technology Division
Technical Bulletin 17-02

Page 7 of 8

April 20, 2017

UNCLASSIFIED/LAW ENFORCEMENT SENSITIVE

843

Keys: ← → or j k turn pages; / finds.